The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 802 - File: showthread.php PHP 7.4.33 (Linux)
File Line Function
/showthread.php 802 errorHandler->error




Raymarine forum / Raymarine Forums / Autopilots v / [CA] [CA11] Redundant Autopilot install

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] [CA11] Redundant Autopilot install
09-04-19, 02:37 PM (This post was last modified: 09-10-19 02:29 PM by Chuck - Raymarine - Moderator.)
Post: #1
Mick Offline
Junior Member
**
 		Posts: 7
Joined: Jun 2016
Reputation: 0
[CA11] Redundant Autopilot install
I am installing a secondary autopilot and want to use the same drive unit. I have a Raymarine Smartpilot S2 installed right now.

The units will power will be wired in a way that will prevent them from being on, at the same time.

Do you see any concern about making the drive connection, via a busbar? So the drive output of each unit would go to a busbar and from the busbar to the drive unit. Would power being present at those terminals, while the Smartpilot is off, cause damage to that unit?

Thanks.
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
[CA11] Redundant Autopilot install - Mick - 09-04-19 02:37 PM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication