The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 802 - File: showthread.php PHP 7.4.33 (Linux)
File Line Function
/showthread.php 802 errorHandler->error





Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] [CA11] Remanufactured Quantum Q24C does nothing when powered up
09-05-19, 10:30 AM (This post was last modified: 09-10-19 03:47 PM by Chuck - Raymarine - Moderator.)
Post: #1
[CA11] Remanufactured Quantum Q24C does nothing when powered up
I've had a remanufactured Quantum Q24C 18", purchased from Flir, sitting under a bunk for a year. This week I started preparation to install the unit, replacing an older Raymarine analog radar.

However, powering the unit up in my saloon (positive 12V and negative ground) the unit does absolutely nothing. If I'm not mistaken I should be seeing a WiFi network with SSID Quantum_xxxxxxx, yet there is no WiFi network like that.

I am planning on a setup with a WiFi connection between the Q24C and my ES98 chart plotter.

Anything else I should be doing to power this on? PS: after using a powerprobe to inject per I tried jumper leads from the house bank as well. Nothing.
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
[CA11] Remanufactured Quantum Q24C does nothing when powered up - rudykruger - 09-05-19 10:30 AM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)