[CA11] interfacing EV-1 to Coastal navigator software

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Threaded Mode | Linear Mode

[CA] [CA11] interfacing EV-1 to Coastal navigator software

09-14-19, 06:58 AM (This post was last modified: 09-16-19 08:41 AM by Chuck - Raymarine - Moderator.)

Post: #3

captainjoez Offline

Junior Member

Posts: 2
Joined: Jun 2017
Reputation: 0

RE: [CA11] interfacing EV-1 to Coastal navigator software

According to Vesper, the unit will convert NEMA 0183 to NEMA 2000 and visa-versa. I have my laptop with Rose Point's Coastal Navigator software connected to the Vesper XB-8000 along with the Raymarine autopilot. When I command the nav system to activate route, I get no response from the autopilot.

« Next Oldest | Next Newest »

Messages In This Thread

[CA11] interfacing EV-1 to Coastal navigator software - captainjoez - 09-12-19, 05:24 PM

RE: [CA11] interfacing EV-1 to Coastal navigator software - Chuck - Raymarine - Moderator - 09-13-19, 09:14 AM

RE: [CA11] interfacing EV-1 to Coastal navigator software - captainjoez - 09-14-19 06:58 AM

RE: [CA11] interfacing EV-1 to Coastal navigator software - Chuck - Raymarine - Moderator - 09-16-19, 09:01 AM

User(s) browsing this thread: 1 Guest(s)