The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 802 - File: showthread.php PHP 7.4.33 (Linux)
File Line Function
/showthread.php 802 errorHandler->error




Raymarine forum / Raymarine Forums / Multifunction Displays v / [LW] [LW11] Axiom Pro with ECI-100, adding stand alone oil temp telegram

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[LW] [LW11] Axiom Pro with ECI-100, adding stand alone oil temp telegram
10-22-19, 04:10 PM (This post was last modified: 10-23-19 03:27 AM by Louise - Raymarine - Moderator.)
Post: #1
mmosberg Offline
Junior Member
**
 		Posts: 3
Joined: Jun 2019
Reputation: 0
[LW11] Axiom Pro with ECI-100, adding stand alone oil temp telegram
I have a Yanmar 6LY engine connected to Axiom Pro via ECI-100. The engine is not fitted with an engine oil temperature sensor. I want to be able to monitor the oil temp on the MFD and am planning to install a resistive sensor on the oil distribution block and wire it to a KUS NKC42 analog to NMEA 2000 converter. The KUS unit will be wired to the backbone on a T-piece. The KUS unit will be configured to transmit "Engine Oil Temperature" NMEA 2000 telegrams.

Question: Will the Axiom MFD accept to receive engine data from two different sources? Can I customize my engine data page and get the oil temp signal displayed together with the other engine data?
MY 2003 Windy 32 Scirocco HT, 2xKAD300
Callsign LD3800
MMSI 257076050
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
[LW11] Axiom Pro with ECI-100, adding stand alone oil temp telegram - mmosberg - 10-22-19 04:10 PM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication