[CA] [CA11] ST60 and ST60CH issues with new wind vane
|
10-22-19, 04:34 PM
(This post was last modified: 10-23-19 09:28 AM by Chuck - Raymarine - Moderator.)
Post: #1
|
|||
|
|||
[CA11] ST60 and ST60CH issues with new wind vane
I have the following issues with my wind Raytheon ST60 and Raytheon ST60CH instruments:
They do not show accurate wind angles, the wind speed is not accurate and constantly changes from anything to 99.9 knots. After certain time the instruments beep 4 or 5 times and reboot showing "---" and then the cycles repeat themselves. My boat has one Raytheon ST60 and one Raytheon ST60CH(close-hauled) as a repeater. While our must was out we replaced the wiring and installed a new ST60. The older wind vane was with cups that are shaped like trapezoids, I think it must be the older ST50. I checked the voltage and the wiring and everything is OK. Here is what I have tried: I have reset the ST60 displays to the factory settings and linearised them by going 2 full circles. That helped a little with the wind angles but not with spped and the ST60 still resets themself. Is there anyone I could consult with to fix these issues? |
|||
« Next Oldest | Next Newest »
|
Messages In This Thread |
[CA11] ST60 and ST60CH issues with new wind vane - beckett - 10-22-19 04:34 PM
RE: [CA11] ST60 and ST60CH issues with new wind vane - Chuck - Raymarine - Moderator - 10-23-19, 09:39 AM
RE: [CA11] ST60 and ST60CH issues with new wind vane - beckett - 10-25-19, 04:52 AM
RE: [CA11] ST60 and ST60CH issues with new wind vane - Chuck - Raymarine - Moderator - 10-25-19, 08:08 AM
|
User(s) browsing this thread: 1 Guest(s)