Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[TG] [TG11] MFD Lockup-alarm active
03-07-20, 08:24 PM
Post: #8
RE: [TG11] MFD Lockup-alarm active
Something to add that i just found.

I made a new route to a new fishing spot.
It started just past an old route.
The new route worked perfectly.
I did not on this occasion follow the old route but close to the end of that route, I followed the new route.
On this new route, the MFD DID NOT give a waypoint alarm alarm like the old route. The P70r asked for turn permission at each waypoint as usual.

Unfortunately, when i got home I modified this new route by adding the waypoints in the old route to the start of new route.

I backed up the routes and used a text editor to see if there were any differences. There are in fact differences

I copied the relevant sections of the GPX file of the route to a text file called RouteDifference.txt which I have attached. (hey, I don't have a life!)

It contains the last waypoint (out6) of the old route and the first waypoint ( waypoint26) of the new.

The definition of waypoint26 contains 2 extra lines

<raymarine:GroupGUID>d58b-3d18-0001-510e</raymarine:GroupGUID>
<raymarine:GroupName>Al</raymarine:GroupName>

and the time portion of out6 is set to T00:00:00Z

The old route was created on my old boat using lighthouse2 (E125).

I have also attached the full route file.
The route called OUTWARD is the old route created with lighthouse 2
The other routes have (usually) been created by adding the outward route waypoints to new routes.
The new route is called "Deep Drop Moreton 350m"
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: [TG11] MFD Lockup-alarm active - BernieK - 03-07-20 08:24 PM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)