The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 802 - File: showthread.php PHP 7.4.33 (Linux)
File Line Function
/showthread.php 802 errorHandler->error




Raymarine forum / Raymarine Forums / Autopilots v / [CA] [CA11] P100 Remote Not Changing Heading - ST7001+ Autopilot

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] [CA11] P100 Remote Not Changing Heading - ST7001+ Autopilot
11-13-19, 04:44 PM (This post was last modified: 11-14-19 01:21 PM by Chuck - Raymarine - Moderator.)
Post: #1
hubesail Offline
Junior Member
**
 		Posts: 40
Joined: May 2016
Reputation: 0
[CA11] P100 Remote Not Changing Heading - ST7001+ Autopilot
Hi,

I have an S100 remote with an ST7001+ autopilot. Today I was having trouble with the S100 remote turning off when I switched from Standby to Pilot on the remote. I replaced the batteries but found that the negative spring on one side was bent out of shape and didn't fully contact the battery terminal. I very gently bent it back into shape. The S100 powered up fine and will now switch from Standby to Pilot, BUT then the remote won't change heading.

When I switch to Pilot using the S100 remote, the ST7001+ does shift to Auto and then it works fine. The S100 beeps like it always had, but nothing happens; the heading stays the same.

Any ideas???

Thanks, Hube Hopkins
M/V Aurora
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
[CA11] P100 Remote Not Changing Heading - ST7001+ Autopilot - hubesail - 11-13-19 04:44 PM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication