The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 802 - File: showthread.php PHP 7.4.33 (Linux)
File Line Function
/showthread.php 802 errorHandler->error

Post Reply 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] [CA11] i70s where does compass go
11-19-19, 01:01 PM (This post was last modified: 11-19-19 01:46 PM by Chuck - Raymarine - Moderator.)
Post: #1
[CA11] i70s where does compass go
I am replacing some 3 old ST50/60's with 3 - i70s'
I have an ITC-5 to convert the wind, depth speed to STg.

Currently there is a Gyroplus 2 SHS installed. I believe that also means that somewhere on the boat is a fluxgate compass. I think the SHS outputs ST which I believe I can connect through a converter to the STg network. The boat has no autopilot. One of the ST50's displayed heading so I believe that was its only use.

Initially I was doing some research to see if I should remove the SHS and connect the compass directly to the ITC-5 and then found that the compass is "discontinued".

Assuming I can continue to use what I have for the time being. Does it make more sense to connect the compass directly to the ITC-5 or take the ST output from the SHS and convert/connect to the STg network?

What is the replacement for the compass, would that be the EV-1/2 sensor core ?

Find all posts by this user
Quote this message in a reply
Post Reply 

Messages In This Thread
[CA11] i70s where does compass go - [email protected] - 11-19-19 01:01 PM

Forum Jump:

User(s) browsing this thread: 1 Guest(s)