Raymarine forum / Raymarine Forums / Multifunction Displays v / [CA] Axiom 9" on LH 3.3 with Fresh Water PGN

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] Axiom 9" on LH 3.3 with Fresh Water PGN
02-22-18, 03:33 AM (This post was last modified: 02-22-18 04:32 PM by Chuck - Raymarine - Moderator.)
Post: #1
watsala Offline
Junior Member
**
 		Posts: 37
Joined: Nov 2017
Reputation: 0
[CA] Axiom 9" on LH 3.3 with Fresh Water PGN
I hooked up a Antisense today which sends fuel level (PGN 127505) for both my fuel tanks.

I also am trying to send Fresh Water level (also PGN 127505) but a different ID. I can see the sentences on the network but the gauge on the Axiom Pro 9" is showing 0%.

I am on LH 3.3 dated Jan 2018.

Does the Axiom support fresh water? What else can I check.

Thanks

W
Find all posts by this user
Quote this message in a reply
02-22-18, 04:59 PM
Post: #2
Chuck - Raymarine - Moderator Offline
Administrator
*******
 		Posts: 14,319
Joined: Oct 2014
Reputation: 43
RE: [CA] Axiom 9" on LH 3.3 with Fresh Water PGN
Welcome to the Raymarine Forum watsala,

Please click here to view a FAQ addressing this subject. Should you have configured the fresh water tank's NMEA 200 fluid level sensor as specified within the referenced FAQ and should the problem persist, then please attach a screen snapshot showing the NMEA 2000 analyzer's (ex. Actisense NMEA Reader software via Actisense NGT-1, etc.) output for PGN 127505 for the fresh water tank's fluid level sensor for further analysis.
Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication