power/data cable from Radar quantum
|
11-09-16, 09:42 AM
Post: #1
|
|||
|
|||
power/data cable from Radar quantum
The power/data cable from the quantum has three wires for power. Red, Black and Green. We are connecting to a distribution panel.
Do we use the green wire and if so do we connect it to negative as well as the black? |
|||
11-10-16, 09:38 AM
Post: #2
|
|||
|
|||
RE: power/data cable from Radar quantum
Welcome to the Raymarine Forum Lazybones,
The radar cable's green lead is its drain lead. Please click here to view a FAQ addressing product drain leads. |
|||
11-14-16, 08:18 PM
Post: #3
|
|||
|
|||
RE: power/data cable from Radar quantum
Can the use of a dyna plate which is used for the RF copper ground of a SSB be used for the drain wire?
|
|||
11-15-16, 09:46 AM
Post: #4
|
|||
|
|||
RE: power/data cable from Radar quantum
Lazybones,
As long as the SSB is properly grounded, the drain leads of the other marine electronics may also be connected to the Dynaplate which the SSB has been interfaced to. It is recommended that you verify that the Dynaplate has also been connected to the boat's engine block. |
|||
11-15-16, 06:53 PM
Post: #5
|
|||
|
|||
RE: power/data cable from Radar quantum
There are two dyna playes in tandem and they are not connected to the engine block, should they be?
|
|||
11-16-16, 10:02 AM
Post: #6
|
|||
|
|||
RE: power/data cable from Radar quantum
Lazybones,
Yes, the Dynaplates should be connected to the engine block. |
|||
« Next Oldest | Next Newest »
|
User(s) browsing this thread: 1 Guest(s)