Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
E127 will not boot after latest software update
06-02-16, 03:40 PM
Post: #1
E127 will not boot after latest software update
I updated my E127 to the latest software and it will not boot. It goes into a cycle of giving the Raymarine screen then flashes the home screen top ribbon only and then restarts etc. I have reinstalled the update twice with no improvement.

Please advise
Find all posts by this user
Quote this message in a reply
06-03-16, 03:50 PM
Post: #2
RE: E127 will not boot after latest software update
Welcome to the Raymarine Forum epc7405,

Should power to the MFD be interrupted, then the reported issue may occur. It is recommended that you try to reset the MFD to correct the problem. Should this not correct the problem, then the MFD will need to be sent to Raymarine’s Product Repair Center to be serviced.

http://www.raymarine.com/knowledgebase/i...?view=3806
Visit this user's website Find all posts by this user
Quote this message in a reply
06-06-16, 10:55 AM
Post: #3
RE: E127 will not boot after latest software update
Per epc7405: "please disregard the prior post I downloaded the updated again and reinstalled with no problems. I must have had a corrupted card. The A9 however had to be reset to factory before I could get it to boot properly."
Visit this user's website Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)