Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA11] Interfacing SmartPilot S3G course computer to Garmin gpsmap 4208
01-09-20, 01:32 PM (This post was last modified: 01-09-20 01:32 PM by Chuck - Raymarine - Moderator.)
Post: #2
RE: [CA11] Interfacing SmartPilot S3G course computer to Garmin gpsmap 4208
Welcome to the Raymarine Forum George,

Were this not involving a legacy Raymarine autopilot and a third party NMEA 2000 system, I might have suggested that a SeaTalk to SeaTalkng Converter Kit be used as part of the solution. However, the time proven solution would be to simply:
- interface the 4800 BAUD NMEA 0183 output port of the third party chartplotter/MFD to the NMEA 0183 input port of either the autopilot's control head or course computer.

If additionally desiring to have the heading and/or rudder angle data supplied to the third party chartplotter/MFD:
- interface the 4800 BAUD NMEA 0183 input port of the third party chartplotter/MFD to the NMEA 0183 Port 1 OUT of the autopilot's course computer.
Visit this user's website Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: [CA11] Interfacing SmartPilot S3G course computer to Garmin gpsmap 4208 - Chuck - Raymarine - Moderator - 01-09-20 01:32 PM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)