Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Magnetron current reads 0
06-05-16, 04:14 PM
Post: #1
Magnetron current reads 0
I am not receiving any radar video on my E120 from the 4ft open array. It was working fine and now no video display. Ran a self test on the 3nm range. Magnetron current 0 and magnetron heater fail.
Find all posts by this user
Quote this message in a reply
06-24-16, 04:09 PM
Post: #2
RE: Magnetron current reads 0
Welcome to the Raymarine Forum Garry,

The symptoms reported are indicative of a failure within the pedestal core. If the 4kW radar a HD Digital 4kW or SHD 4KW, then the radar core should be sent to Raymarine’s Product Repair Center to be serviced. However, should the 4kW radar be an analog 4kW radar, then the radar pedestal / array assembly and the radar cable will need to be replaced with a Digital Radar Cable and HD Digital 4kW or SHD Digital 4KW Open Array Radar.
Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)