Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[LW] [LW11] ST 5000+
01-20-20, 02:30 PM (This post was last modified: 01-21-20 06:24 AM by Louise - Raymarine - Moderator.)
Post: #1
[LW11] ST 5000+
I someone can help me. I have a faulty Raymarine ST4000+ control head on my sailing boat (wheel steering). I have been told it can’t be repaired. I have been able to source a good Raytheon ST5000+ control head. Can I replace them like for like? What is the difference (if any) between them? Do I need to adjust any settings? Thanks
Find all posts by this user
Quote this message in a reply
01-21-20, 09:56 PM
Post: #2
RE: [TG11] ST 5000+
Hello Neil,

We haven't had any spares for ST4000+ displays for some years, they were retired a long time ago. And attempting component-level repairs on modern surface-mount PCBs tends not to be either economic in labour time or very reliable.

Yes, you can use an ST5000+, it's actually the same circuit board. Just go into the dealer calibration and set the Drive type correctly ('4000 WHL') and do the rest of the calibration as for a new installation.

Regards,
Tom

Raymarine since 1999.
Interests: Diagnosis of problems in sonar/fishfinders, NMEA2000, ethernet comms, autopilots, thermal cameras
Location: Sydney, Australia.

Please don't PM me asking for direct support, please ask a public question instead so that others can see the question and answer. Forum posts will always be answered before PM requests.
Visit this user's website Find all posts by this user
Quote this message in a reply
01-22-20, 06:14 AM
Post: #3
RE: [LW11] ST 5000+
That’s great. Thanks for your help Tom.
Regards Neil
Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)