Raymarine forum / Raymarine Forums / Multifunction Displays v / [CA] [CA11] Using Element 7S to update system components

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] [CA11] Using Element 7S to update system components
02-06-20, 03:30 PM (This post was last modified: 02-06-20 04:05 PM by Chuck - Raymarine - Moderator.)
Post: #7
spencerdd Offline
Junior Member
**
 		Posts: 18
Joined: Jan 2017
Reputation: 0
RE: [CA11] Using Element 7S to update system components
Thank you Chuck,
I was following guidance from para 4.5 from the Lighthouse Sport V3.10.10 manual and an earlier FAQ here http://forum.raymarine.com/showthread.php?tid=6774 (There's a picture of it printed to beside my bench test setup). The updated FAQ that you referenced was very helpful. The key was to get to HOME->SET-UP->GETTING STARTED->UPDATE SOFTWARE->CHECK SD CARD which immediately "woke up" the SD card and I was given the options to update s/w on my i70s, p70s and ACU-100.
All s/w is now up to date and I'm looking forward to installing everything once the weather is suitable.
Thanks again for your prompt and helpful assistance.

Dave
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: [CA11] Using Element 7S to update system components - spencerdd - 02-06-20 03:30 PM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication