Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] [CA11] Chartplotter Compatibility
01-29-20, 11:24 AM (This post was last modified: 01-29-20 02:53 PM by Chuck - Raymarine - Moderator.)
Post: #1
[CA11] Chartplotter Compatibility
Hello, I would like to know what current chartplotter products will work with my older radar, autopilot, and sounder, if any. My current system works fine but I know that it is not really supported anymore. This is my current setup: I would like keep all of my products except my chartplotter. Thanks, VR. Todd

E80 Chartplotter
RD418D 4kw 18” Radome
DSM 300 Sounder
ST70 Autopilot Controller
SPX 10 SmartPilot System
Find all posts by this user
Quote this message in a reply
01-29-20, 03:05 PM (This post was last modified: 01-29-20 03:06 PM by Chuck - Raymarine - Moderator.)
Post: #2
RE: [CA11] Chartplotter Compatibility
Welcome to the Raymarine Forum Donzii150,

Both Axiom and Axiom Pro MFDs are compatible RD418D radome and SPX autopilot. Please additionally note that the DSM30/300 fishfinder sounder modules are not officially supported for use with Axiom/Axiom Pro/Axiom XL systems. Specifically, these systems have not been designed for use with nor officially tested with DSMs. However, anecdotal feedback from customers has indicated no issues thus far in using an operational DSM30/300 with Axiom/Axiom Pro/Axiom XL systems. Accordingly, should your DSM300 be operational, then you might want to try it out with the new Axiom or Axiom Pro system before either:
- replacing it with a CP370 fishfinder sounder module. In such cases, either an Axiom 12 (cost savings) or Axiom RV 12 MFD may be installed; or
- adapting the transducer to be mated to the Axiom DV, Axiom RV, or Axiom Pro RVX Transducer socket.

Please click here to view a FAQ addressing replacement of an E-Series Classic MFD with an Axiom MFD. If electing this option, then an Axiom 9 DV or Axiom 9 RV MFD would be recommended form the standpoint of similar MFD size to the E80 and if seeking to adapt the currently installed fishfinder transducer. Otherwise and Axiom 9 MFD may be used.

Please click here to view a FAQ addressing replacement of an E-Series Classic MFD with an Axiom Pro MFD. If electing this option, then an Axiom Pro 9 RVX MFD would be recommended form the standpoint of similar MFD size to the E80 and if seeking to adapt the currently installed fishfinder transducer. Otherwise and Axiom Pro 9 S MFD may be used.
Visit this user's website Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)