[LW] [LW11] Axiom Pro MFD, no Tempsensor-readings

[JanneHson]

Hello,

I have a problem to get any temperature readings in my Axiom Pro 9" MFD from Airmar dst800 triducer

System is Airmar dst 800 triducer connected to Raymarine Itc 5 converter, connected to seatalk backbone Cable to seatalkng converter plint to Axiom Pro MFD and also ST60 instruments

Everything seems ok, i have checked airmar temp sensor = ok
Itc5 Cables connected i right colors from triducer = ok
Itc5 led = ok
Speed info in MFD = ok
Deep info in MFD = ok

But Temp info = 0,0 (it should be about 12 deegres when i tested)

I cant find any sonar menu to enable temp sensor ?? (if that is the problem ?)

Please any idea ?

Regards /Janne

[Tom - Raymarine - Moderator]

Hello Janne,

To confirm that the temperature data (0,0) is coming from the DST800, what happens when you disconnect brown or white from the ITC5? Does temperature go to dashes ( -.- degrees)?

Can you measure the resistance on the DST800 brown and white wires, when disconnected from the ITC5? At 12 degrees it should read something around 13-15 kOhms, but if there's a problem with the DST's thermistor then it will read something well outside this range.

Is there any depth transducer connected to the Axiom Pro?

Regards,
Tom