Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] [CA11] Linking Two e127
02-21-20, 03:32 PM (This post was last modified: 02-21-20 03:38 PM by Chuck - Raymarine - Moderator.)
Post: #1
[CA11] Linking Two e127
I had an original e127 in console already and purchased another tow have two. After powering the second MFD what cable or how do I link the two together to work off each other and share information?


Attached File(s) Thumbnail(s)
       
Find all posts by this user
Quote this message in a reply
02-21-20, 03:46 PM
Post: #2
RE: [CA11] Linking Two e127
Welcome to the Raymarine Forum PuraPintura,

Fishfinder, radar, and cartography features cannot be shared among the system's MFDs when they have been networked via a SeaTalkng / NMEA 2000 backbone alone. Proper installation would require that the MFD's be interfaced to one another or to a HS5 RayNet Network Switch via an appropriate length of RayNet (F) to RayNet (F) Cable. One of the MFDs will be interfaced to the backbone and will be the only MFD within the system (even though others may be interfaced to the backbone) which will communicate with the backbone. This MFD will be designated as the system's Data Master. The system's Data Master MFD will share data from the system's backbone to the system's other networked MFDs. All MFDs must be operating with the same version of software ... in this case LightHouse II v19.03 software is recommended.
Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 2 Guest(s)