The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 802 - File: showthread.php PHP 7.4.33 (Linux)
File Line Function
/showthread.php 802 errorHandler->error





Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] [CA11] 4K open array not working with E120
02-26-20, 11:56 AM (This post was last modified: 02-26-20 03:52 PM by Chuck - Raymarine - Moderator.)
Post: #1
[CA11] 4K open array not working with E120
I was helping a customer replace an older e-120 with an older but new E120. He also wanted to change the open array with a used one that wasn't discolored and relocate the array and motor. I unbolted the array, lifted it off and replaced it with the other unit also pulling the 8 pin plug, + and - wires. All power was off throughout the process, the plug was wired back up to spec. Power was turned on and every thing worked except the screen only displayed about 1/8 mile after any adjustment I was familiar with. I put the original array back on and the problem remained. He says everything worked fine with the old E120 and array and I must have damaged the radar. Is that even possible when carefully replacing the open array and plug?
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
[CA11] 4K open array not working with E120 - rob minks - 02-26-20 11:56 AM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)