Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA11] M232 W/Axiom MFD's - no video
03-27-20, 05:04 PM (This post was last modified: 03-30-20 11:01 AM by Chuck - Raymarine - Moderator.)
Post: #1
[CA11] M232 W/Axiom MFD's - no video
Hello,

So last year I installed a 232 and a couple Axiom 12's
Everything went well on the install, a couple times there would be no video from the thermal, I could pull the fuse and it would take off and work

I updated to the latest LH software last week, we go out last night and no image (I can still control the cam - pan/tilt)
I do my fuse trick 3 different times, no luck

Any ideas?

TIA

Nick
Find all posts by this user
Quote this message in a reply
03-30-20, 12:19 PM
Post: #2
RE: [CA11] M232 W/Axiom MFD's - no video
Welcome to the Raymarine Forum Nick,

It is recommended that the power and ground be inspected from the camera through to breaker panel and ground to ensure that all connections are tight and free of corrosion. Should any inline fuses be installed in the camera's power circuit, then these too should be inspected. If no issues are found, then please indicate whether the system include a Joystic Control Unit. Alternatively, the MFDs may be the only means of interacting with the camera. Finally, has the camera been interfaced to a network switch or directly to the MFD?
Visit this user's website Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)