Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] [CA11] 3 MFDs Through HS5 RayNet Network Switch?
04-29-20, 04:30 PM
Post: #11
RE: [CA11] 3 MFDs Through HS5 RayNet Network Switch?
I'm sorry to be dense. if they all go to the switch what is the point of the 5-Way SeaTalkng Connector?
Find all posts by this user
Quote this message in a reply
04-30-20, 01:36 AM (This post was last modified: 04-30-20 01:40 AM by Jules - Raymarine - Moderator.)
Post: #12
RE: [CA11] 3 MFDs Through HS5 RayNet Network Switch?
Hi Steve,

STng network (low bandwidth) shares "number data" to units connected by STng cables

RayNet network (high bandwidth) shares "graphical data" to units connected by RayNet cables

Hope this explains it simply.

Kind regards

Jules
Find all posts by this user
Quote this message in a reply
05-01-20, 02:49 PM
Post: #13
RE: [CA11] 3 MFDs Through HS5 RayNet Network Switch?
If I connect all the MFD to the SWITCH using Raynet cables will they then share the data? It is still not clear... what is the point of the 5-Way SeaTalkng Connector?
Find all posts by this user
Quote this message in a reply
05-04-20, 09:03 AM
Post: #14
RE: [CA11] 3 MFDs Through HS5 RayNet Network Switch?
Hi Steve,

MFDs, Radars, fishfinders, and IP cameras share a Large amount of data and are connected up on a ethernet based network called Raynet.

Your VHF, ext gps antenna, autopilot or intruments share much less data and are on a seperate network called STNG.

Q1-what is the point of the 5-Way SeaTalkng Connector
A1- If you have a STNG device, some examples are above, that device would connect to a STNG five way and the Master MFD would then connect to the STNG five way.
The master mfd would then act as the "traffic cop" to route data through the system.

Chris,
Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)