Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[TG] [TG11] Linear Drive Type 2 Long vs Short
04-15-20, 04:12 PM (This post was last modified: 04-15-20 04:16 PM by Chuck - Raymarine - Moderator.)
Post: #1
[TG11] Linear Drive Type 2 Long vs Short
Hi, I am about to replace my Type 2 Linear drive. My yacht, weighs about 16,000kg fully loaded with a long keel and huge rudder. I removed the old unit which was a Type 2 Short and purchased a Type 2 Long to replace it with due to the weight of our yacht and the fact that we sail ocean crossings often.
Reading the installation manual Figure 4 Drive Alignment indicates a tiller arm radius of 250mm for the Short and 355mm for the Long.
My tiller arm radius is only 255mm but with the weight of the yacht am I still okay to install the Type 2 Long with the 255mm tiller arm radius? Thanks.
Find all posts by this user
Quote this message in a reply
04-17-20, 05:19 AM
Post: #2
RE: [TG11] Linear Drive Type 2 Long vs Short
Hi Craig,
I believe I have just responded to your recent post? Apologies for the delay,
Regards
Derek
Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)