Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA11] Axiom 9 RVX adapter to B744V Transducer
04-19-20, 05:41 PM (This post was last modified: 04-21-20 12:57 AM by Sea Tiger.)
Post: #1
[CA11] Axiom 9 RVX adapter to B744V Transducer
I have removed my Classic E80 MFD and associated navigation system and have added an Axiom Pro 9 RVX MFD, I have an existing Airmar B744V 50/200kHz-A PN: 31-313-2-01 Rev.09 Customer Part # E66056 that will stay in the hull this year. I am also installing the RV-100 Transducer on the transom. Please provide the correct Y-adapter cable or adapter needed for connection to the Axiom Pro and both transducers.

I am aware that the transducer cable for the B744V no longer pairs to the DSM300 and it has been removed from the vessel.

I just wanted give you all a big thank you, as I have removed almost all of my 2005 era electronics and replaced them with current equipment. The forum has been a big help and I will continue to use it as I am quickly becoming a Raymarine addict. I just need to finish up and get back on the water.

I have installed the following:
Axiom Pro 9 RVX MFD
Quantum 2 Doppler Radar
AR200 as my GPS and heading sensor (I do not have autopilot)
ST80 (legacy equipment at rear helm) ST1 to STng
Ray73 VHS/AIS Radio
Shakespeare Galaxy VHS/AIS 8" Antenna
Shakespeare Galaxy AM/FM 8' Antenna

Thanks,


Sea Tiger
Find all posts by this user
Quote this message in a reply
04-20-20, 05:24 PM
Post: #2
RE: [CA11] Axiom 9 RVX adapter to B744V Transducer
Welcome back to the Raymarine Forum Sea Tiger,

Transducers which had been designed to be directly (no adapter) to a DS30, DSM300, or DSM250 may be adapted (part #A80496) to be mated to the 1kW Transducer socket of Axiom Pro RVX MFDs.
Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)