Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] [CA11] AutoRoute to here
04-25-20, 08:50 AM (This post was last modified: 04-27-20 01:08 PM by Chuck - Raymarine - Moderator.)
Post: #1
[CA11] AutoRoute to here
When I long hold on my chart the black box come up, but does not have autoroute to here option. I can select goto it makes a straight route. Then I can push on waypoint again black box come up I have option AutoRoute to select it and it builds the route. Then have touch straight route and push stop. Then I have to go to routes select that route and push Follow. Why am I not getting AutoRoute To Here option? thanks Dave
Find all posts by this user
Quote this message in a reply
04-27-20, 01:20 PM
Post: #2
RE: [CA11] AutoRoute to here
Welcome to the Raymarine Forum Dave,

Please ensure that the MFD has been updated with LightHouse 3 v3.11.42 or later software and that the Navionics chart card being used has an active Navionics Freshest Data subscription. If so, then holding you finger to the Chart application's screen should cause the Chart pop-up dialog to appear. Selecting "more options' from the bottom of the dialog will then display additional options where you will find the Autoroute to here option.
Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)