The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 802 - File: showthread.php PHP 7.4.33 (Linux)
File Line Function
/showthread.php 802 errorHandler->error





Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[JB] Trouble with SeaTalk connectors
05-11-20, 09:11 AM (This post was last modified: 05-13-20 08:17 PM by Jules - Raymarine - Moderator.)
Post: #1
Trouble with SeaTalk connectors
I am having a new problem with SeaTalk ng connectors. I have plugged/unplugged these connectors previously with no problems whatsoever, but in the process of installing a new system with some new/longer backbone cabling I have had a helluva time with unplugging newly installed cabling from my 5-way connectors and T-connectors. They install easily enough, and the system has even ops checked good, but when disconnecting those same connections they simply won't pull out no matter what. Perhaps I should carefully lubricate the small o-rings on the cable connector end before inserting? If so, wondering if there is a recommended lubricant or process? This is all I can figure to do. Thanks for any advice! A search of the internet for similar complaints came up with nothing...

David
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
Trouble with SeaTalk connectors - tyed - 05-11-20 09:11 AM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)