Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[TG] [TG11] Two i70
05-11-20, 02:56 PM (This post was last modified: 05-13-20 10:40 PM by Tom - Raymarine - Moderator.)
Post: #1
[TG11] Two i70
Currently have one i70, iTC5 and e95, p70, SPX30, i50 (repeater), i60 (repeater).
I have a second i70 I’d like to connect. Will the settings in existing i70 be reset, or would second i70 assume the settings of the first? Are settings for transducers stored in iTC5 or i70?
Thank you!
Find all posts by this user
Quote this message in a reply
05-13-20, 10:43 PM
Post: #2
RE: [TG11] Two i70
Hello billc42,

Transducer calibration is always stored in the source device (ITC5 in this instance.) The only things that an i70 stores locally are things like page layouts and language setup. Language selection is system-wide (a message is sent around at the time when you make a selection, but not at other times), whereas page setup on i70 is display-local.

In short, you don't have to worry about a new i70 over-writing existing system setup.

Regards,
Tom

Raymarine since 1999.
Interests: Diagnosis of problems in sonar/fishfinders, NMEA2000, ethernet comms, autopilots, thermal cameras
Location: Sydney, Australia.

Please don't PM me asking for direct support, please ask a public question instead so that others can see the question and answer. Forum posts will always be answered before PM requests.
Find all posts by this user
Quote this message in a reply
05-14-20, 06:11 PM
Post: #3
RE: [TG11] Two i70
Thanks!
Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)