Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[TG] [TG11] ES128 will not accept LH3 software
05-17-20, 01:55 AM (This post was last modified: 05-20-20 01:49 AM by Tom - Raymarine - Moderator.)
Post: #1
Question [TG11] ES128 will not accept LH3 software
Hi!
Have an es128, downloaded LH3 firmvare and as textile in unzipped files describes the two iso files should be placed on two separate sd cards.
Follows the instructions and plotter reboots and start loading different base maps. After a while plotter starts up with LH2...
Any tips on this?
Radar is in in stb modus.
//Haakon.
Find all posts by this user
Quote this message in a reply
05-20-20, 01:53 AM
Post: #2
RE: [TG11] ES128 will not accept LH3 software
Hello Haakon,

That sounds like you're installing the updates in the wrong order. It's not made obvious in the download (apologies for this), but you need to insert the card with raymarine_atom-3.11.42.upgrade.iso on it first (the main LH3 software) and then once that has installed, do the ray_mfd_AtomCartographyRX5v1_22.upgrade.iso upgrade afterwards. You may see a warning saying that the second upgrade has failed, but don't worry about this, it's a false failure.

Regards,
Tom

Raymarine since 1999.
Interests: Diagnosis of problems in sonar/fishfinders, NMEA2000, ethernet comms, autopilots, thermal cameras
Location: Sydney, Australia.

Please don't PM me asking for direct support, please ask a public question instead so that others can see the question and answer. Forum posts will always be answered before PM requests.
Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)