Raymarine forum / Raymarine Forums / Autopilots v / [TG] [TG11] Edson Rudder Arm - Linear drive mounting location

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[TG] [TG11] Edson Rudder Arm - Linear drive mounting location
05-27-20, 09:45 AM
Post: #1
clburti Offline
Junior Member
**
 		Posts: 11
Joined: Mar 2016
Reputation: 0
[TG11] Edson Rudder Arm - Linear drive mounting location
I am upgrading our EV-100 Raymarine Wheel Pilot installed in a Catalina 320 to an ACU-200 and Type 1 Linear Drive. Edson advised me to check with Raymarine on how far from center of rudder shaft to drill the rudder arm for the tiller pin.
Thanks,
CB
Find all posts by this user
Quote this message in a reply
06-01-20, 11:29 PM
Post: #2
Tom - Raymarine - Moderator
Unregistered
 		 
RE: [TG11] Edson Rudder Arm - Linear drive mounting location
Hello clburti,

You can find the Linear Drive's installation manual here, which will give this and other mounting dimensions.

Regards,
Tom
Quote this message in a reply
06-03-20, 07:37 AM
Post: #3
clburti Offline
Junior Member
**
 		Posts: 11
Joined: Mar 2016
Reputation: 0
RE: [TG11] Edson Rudder Arm - Linear drive mounting location
Thanks, somehow I missed that information while reading the instructions...
Thanks,
CB
Find all posts by this user
Quote this message in a reply
06-05-20, 12:15 AM
Post: #4
Tom - Raymarine - Moderator
Unregistered
 		 
RE: [TG11] Edson Rudder Arm - Linear drive mounting location
No problem, I'm glad you found the answer you were after.

Regards,
Tom
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication