Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
E120 fails to read known good CF card
06-07-20, 09:35 PM
Post: #1
E120 fails to read known good CF card
I have an E120 that I have been using in a slave mode (connected via SeaTalkHS) to a master E120 (that has the chart card).

My Master E120 failed so I though I would just pop the chart card out of the master unit and into the slave unit but the clave unit refuses to read the card. I have confirmed that the card is good (it has a current Navionics subscription and can be read and updated in my PC) and of course the card was working just fine in the master E120 before it failed (backlight failure).

I have verified that there is no damage to the CF card socket - all pins are there, none are bent and there is no corrosion.

I have run the Verify CF card test and the operation says: Failed to write to CF card.

I have also tried to save my waypoints and routes to the CF card and it also fails.

Does anyone have any idea what might be wrong?

Thanks,
Find all posts by this user
Quote this message in a reply
06-26-20, 03:44 PM
Post: #2
RE: E120 fails to read known good CF card
Hello bobatkins,

I would check that the unit has V5.69 the latest version of sw. If it has an earlier version it will not read the card,

Regards,

Chris,
Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)