Thread Closed 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
MFD is sounding alarm every 30 seconds ... no message displayed
01-19-16, 10:51 AM (This post was last modified: 01-12-17 11:09 AM by Chuck - Raymarine - Moderator.)
Post: #1
MFD is sounding alarm every 30 seconds ... no message displayed
MFD is sounding alarm every 30 seconds ... no message displayed

The Man Overboard (MOB) event is commanded by holding the WPT/MOB button pressed for approximately three seconds. When a MOB has been triggered,
- the MFD will produce an audible alarm and initially display a MOB alert dialog to notify the operator of a MOB event. Following the initial audible alarm, the MFD will sound an audible alarm at approximately thirty second intervals.
- the MOB's position, range, bearing, and time since the MOB event was triggered will be displayed within the Databar
- the MOB's position will be plotted on within the Chart application
- the Chart application will be configured to Auto Ranging in to better display the MOB's location in relation to the vessel
- any previously commanded navigation will be cancelled and a Goto event will be triggered to the location of the MOB. The MOB's position will be plotted on within the Chart application and the Databar.

One may easily verify whether a MOB event has been triggered by examining the contents of the Destination Waypoint Name within the Waypoint Info data item within a Databar, Databox, Data application panel data item, or by displaying the CDI panel within the Data application.

A MOB event may be cancelled by holding the WPTS/MOB button pressed for approximately 3 seconds. Once triggered, the only way to squelch the MOB event's audible alarm is to cancel the MOB event.

RAYFAQ#
Find all posts by this user
Thread Closed 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)