Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Ev100 setup
07-24-16, 08:43 PM
Post: #1
Ev100 setup
Should a on/off switch be on the ACU100 power supply with a 10A in line fuse? Sea Talk backbone power supply requires a 5A in line fuse?
Find all posts by this user
Quote this message in a reply
07-28-16, 02:27 PM
Post: #2
RE: Ev100 setup
Welcome to the Raymarine Forum cddcdccm,

It is indeed recommended that the ACU-100 be powered from a switched 12VDC power circuit which is protected with a 10A fuse. Should the supplying circuit pass through a breaker panel or switched fuse panel, then these items will effectively function to switch power ON/OFF to the ACU-100.
Find all posts by this user
Quote this message in a reply
08-01-16, 02:18 AM
Post: #3
RE: Ev100 setup
Thanks for the reply. I set it up with a switch and inline fuse today. Do I need to run a wire for the RF ground to the negative bus bar? I don't have a ground on my boat.
Find all posts by this user
Quote this message in a reply
08-02-16, 04:02 PM
Post: #4
RE: Ev100 setup
Yes, On vessels without an RF ground system the drain conductor (screen)
should be connected directly to the negative battery terminal.
Find all posts by this user
Quote this message in a reply
08-02-16, 11:22 PM (This post was last modified: 08-03-16 04:08 PM by Mark - Raymarine - Moderator.)
Post: #5
RE: Ev100 setup
Thanks for the help.
Find all posts by this user
Quote this message in a reply
08-03-16, 04:09 PM
Post: #6
RE: Ev100 setup
Your'e welcome.
Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)