Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
E120 Volt display on data bar
08-03-16, 11:43 AM
Post: #1
E120 Volt display on data bar
Hello,

i have two E120s on my boat that are connected to a 4 bank battery system, 1-3 for the three outboards and the 4th or house bank being the one for the electronics of course. I have been unable to find a setting within the E120 that will show the voltage it is receiving from the house bank, does this MFD have the capability to do so? i couldn't find anything in all of the manuals.
Find all posts by this user
Quote this message in a reply
08-31-16, 12:31 PM
Post: #2
RE: E120 Volt display on data bar
Welcome to the Raymarine Forum bobsled,

The E-Series Classic MFDs are not designed to report voltage supplied to the MFDs. When interfaced to a powered and properly terminated SeaTalkng/NMEA 2000 backbone which in turn has been interfaced to a NMEA 2000 engine gateway, these MFDs may report alternator voltage if transmitted by the engine gateway.
Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)