Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
e120 classic network
09-01-16, 10:08 PM
Post: #1
e120 classic network
Here is a lsit of my equipment and a diagram of how it is connected. Is this correct or is the a better way 2-e120 classic, dsm 300, vhf, radar ,flir, acu 200 autopilot
Find all posts by this user
Quote this message in a reply
09-02-16, 10:37 AM
Post: #2
RE: e120 classic network
Welcome to the Raymarine Forum Wayne,

Your diagram appears correct and as would have been advised given the equipment shown. Should you decided to add any additional devices to the SeaTalkng backbone, then it would be advised that the ACU's SeaTalkng power switch be configured to OFF and that a spur socket be installed located at the approximate mid-point of the backbone's LEN load. A SeaTalkng Power Cable to be powered by a switched 12VDC power circuit would then be connected to the spur socket located at the approximate mid-point of the backbone's LEN load.
Visit this user's website Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)