The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 802 - File: showthread.php PHP 7.4.33 (Linux)
File Line Function
/showthread.php 802 errorHandler->error




Raymarine forum / Raymarine Forums / Autopilots v / Autopilot Standby and Auto buttons blinking

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Autopilot Standby and Auto buttons blinking
09-20-16, 09:56 AM
Post: #1
firstlight38 Offline
Junior Member
**
 		Posts: 17
Joined: Aug 2016
Reputation: 0
Autopilot Standby and Auto buttons blinking
When powering up my instruments my ST6000AP had blinking standby and auto buttons and a constant beeping. The display did not show anything. My setup is an A128 MFD connected to STNG and ST60 wind ST60 multi and ST6000AP (on S1 course computer).
This has been working flawlessly since I installed the A128 about 20 months ago. The troubleshooting guide shows nothing regarding the blinking. I assume since the buttons are blinking and there is a beep that the power is reaching the ST6000. The odd thing is, when I set a mark on the MFD and GOTO that mark the AP works as it should.
Any ideas?
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
Autopilot Standby and Auto buttons blinking - firstlight38 - 09-20-16 09:56 AM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication