Autopilot Standby and Auto buttons blinking

[Chuck - Raymarine - Moderator]

Welcome to the Raymarine Forum firstlight38,

The reported problem may be indicative of an under-powered SeaTalk bus or an autopilot control head which is in the initial stages of failure. It is recommended that you verify each SeaTalk to SeaTalkng Converter has been interfaced to and is powering a SeaTalk bus no more than five SeaTalk devices (ex. ST6000, ST60 Wind, etc.). If not, then it is recommended that the vessel be connected to shore power, that it batteries be permitted to be fully charged, and then while still connected to shore power that you attempt to duplicate the problem. Should the problem persist, then is it recommended that the ST6000 and ST-STng Converter to which it has been interfaced be sent to Raymarine’s Product Repair Center to be bench checked / serviced.