Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Wind instrument malfunction
02-20-16, 09:31 AM (This post was last modified: 02-25-16 03:01 PM by Steve - Raymarine - Moderator.)
Post: #3
RE: Wind instrument malfunction
I did this and it made no difference in the display. Wind speed was 0 or very low, while my handheld anemometer is reading around 20 at deck level. Wind direction was radically different than reality and moving all over the place or no indicator at all. I have a depth transducer, flux compass, and wind instrument hooked to my ITC5. I do not have speed and temperature hooked up and I have my rudder indicator hooked directly to the acu200. I noticed that while running the test that the indicator lights on the iTC-5 for the depth and compass were solid on. The speed/temp and rudder lights were flashing. I assume that when the iTC-5 sees a valid transducer the light stays solid and when it doesn't it flashes. The wind indicator light is flashing. Does that help?
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: Wind instrument malfunction - Bill Plaia - 02-20-16 09:31 AM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)