The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 802 - File: showthread.php PHP 7.4.33 (Linux)
File Line Function
/showthread.php 802 errorHandler->error




Raymarine forum / Raymarine Forums / Multifunction Displays v / Yamaha command link engine ID problem

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Yamaha command link engine ID problem
11-09-16, 01:54 PM
Post: #1
Bhngh Offline
Junior Member
**
 		Posts: 21
Joined: Mar 2016
Reputation: 0
Yamaha command link engine ID problem
I have a E127 mfd. and yamaha F225 engines. they are interfaced with command link >E100
Both engines were identifying fine before I upgraded from V16 to V17 software.
Now even if set up as though I only have one engine the starboard engine won't identify.
I know I have the E127 set up correctly because the port engine comes up fine.
And I know I'm getting data voltage at the command link hub from both engines.
I believe the issue may be something with the V17 software because the problem engine is early command link and may be sending some slightly different data that worked on V16 and not V17
I'd like to reinstall V16 to verify this.
Can someone get in touch with me as to how I can get a V16 chip to load up?

714 612 3695
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
Yamaha command link engine ID problem - Bhngh - 11-09-16 01:54 PM

Forum Jump:


User(s) browsing this thread: 2 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication