Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
SeaTalk to SeaTalkng converter setup
02-08-17, 09:28 AM
Post: #16
RE: SeaTalk to SeaTalkng converter setup
Petr,

It is not recommended that the SeaTalkng backbone be powered via the second SeaTalk to SeaTalkng Converter as you have suggested, as it would put a disproportionate amount of the backbone's LEN load on one side of the power insertion spur socket. Again, the goal in powering a SeaTalkng backbone is that its power insertion point be located at the approximate mid-point of the backbone's LEN load. Please click here to view a FAQ addressing this subject. You can also learn more about SeaTalkng networking within the SeaTalkng Reference Manual.
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
SeaTalk to SeaTalkng converter setup - Petersailor - 02-01-17, 03:55 PM
RE: SeaTalk to SeaTalkng converter setup - Petersailor - 02-02-17, 04:02 PM
RE: SeaTalk to SeaTalkng converter setup - Petersailor - 02-02-17, 04:26 PM
RE: SeaTalk to SeaTalkng converter setup - Petersailor - 02-03-17, 03:50 PM
RE: SeaTalk to SeaTalkng converter setup - Petersailor - 02-03-17, 05:52 PM
RE: SeaTalk to SeaTalkng converter setup - Petersailor - 02-03-17, 06:04 PM
RE: SeaTalk to SeaTalkng converter setup - Petersailor - 02-06-17, 04:20 PM
RE: SeaTalk to SeaTalkng converter setup - Petersailor - 02-07-17, 03:53 PM
RE: SeaTalk to SeaTalkng converter setup - Petersailor - 02-08-17, 02:02 AM
RE: SeaTalk to SeaTalkng converter setup - Chuck - Raymarine - Moderator - 02-08-17 09:28 AM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)