Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Wiring help with installation
03-20-17, 01:28 PM (This post was last modified: 03-20-17 03:51 PM by Chuck - Raymarine - Moderator.)
Post: #1
Wiring help with installation
Chuck;

I have attached a wiring schematic of how I installed my new Raymarine products, could you review and let me know if it is properly wired.
I have power to both units, but the i50 is not picking up a depth signal from the transducer.

John Sharkey
Find all posts by this user
Quote this message in a reply
03-20-17, 03:47 PM (This post was last modified: 03-20-17 03:49 PM by Chuck - Raymarine - Moderator.)
Post: #2
RE: Wiring help with installation
Welcome to the Raymarine Forum John,

Your diagram is correct as long as the total spur length is less than or equal to 6m. In order for an i50 Depth/Tridata Instrument to repeat Depth and/or Speed (Temp) data, the instrument must be configured as a Depth Repeater or Speed Repeater respectively. Instructions for configuring the Master / Repeater state may be found within section 6.4 Data master of the i50 Instruments Installation and Operation Instructions.
Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)