Raymarine forum / Raymarine Forums / Autopilots v / ST6000 Disengaging to Standby

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
ST6000 Disengaging to Standby
04-25-17, 12:25 PM (This post was last modified: 04-25-17 12:27 PM by Chuck - Raymarine - Moderator.)
Post: #10
Chuck - Raymarine - Moderator Offline
Administrator
*******
 		Posts: 14,319
Joined: Oct 2014
Reputation: 43
RE: ST6000 Disengaging to Standby
David,

Based upon the spec's of the pump, an Evolution ACU-400 would probably be recommended. The following autopilot equivalents to the ACU-400 preceded the ACU-400 (in order of most recent to oldest design):
- SPX-30
- S3G SmartPilot
- S3
- Type 400G
- Type 400

Again, due to their experience with Octopus drives, it is recommended that Aero Marine Services be contacted to confirm which Evolution ACU would be best suited for use with your Octopus hydraulic pump. Should Aero Marine Services recommend an ACU-400 for your application, then any of the above listed autopilot course computers may be used.
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
ST6000 Disengaging to Standby - deboyes - 03-22-17, 09:19 AM
RE: ST6000 Disengaging to Standby - Chuck - Raymarine - Moderator - 04-25-17 12:25 PM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication