CAM 200IP cabling
|
06-22-16, 06:24 PM
Post: #5
|
|||
|
|||
RE: CAM 200IP cabling
I have been trying to get my CAM200ip operational for the last two weeks. The Raymarine POE that I installed was DOA per a conversation with the support desk. I ordered a replacement and went to the boat today and the second POE was also DOA per the support desk. The LED stays red when I power up the device and never turns green. The voltage in was checked (13.34dc)I have a question about the spec on the POE voltage going down the Ethernet cable to the camera. I can not find anything in the manual about this spec. Is it 12v the same as the pigtail? I am considering using another manufactures POE device. I have confirmed that the camera is ok because I removed the POE and hot wired 12v to the camera pig tail. It would be difficult to add a dedicated 12 volt supply line up on the mast on the boat.
|
|||
« Next Oldest | Next Newest »
|
Messages In This Thread |
CAM 200IP cabling - Pdog1989 - 03-03-16, 01:39 PM
RE: CAM 200IP cabling - Chuck - Raymarine - Moderator - 03-03-16, 01:55 PM
RE: CAM 200IP cabling - Pdog1989 - 03-03-16, 01:58 PM
RE: CAM 200IP cabling - Chuck - Raymarine - Moderator - 03-03-16, 02:41 PM
RE: CAM 200IP cabling - george123 - 06-22-16 06:24 PM
RE: CAM 200IP cabling - Chuck - Raymarine - Moderator - 06-23-16, 07:47 AM
RE: CAM 200IP cabling - george123 - 06-23-16, 09:19 AM
RE: CAM 200IP cabling - george123 - 06-23-16, 02:12 PM
RE: CAM 200IP cabling - Chuck - Raymarine - Moderator - 06-23-16, 02:13 PM
RE: CAM 200IP cabling - george123 - 06-23-16, 04:04 PM
RE: CAM 200IP cabling - Chuck - Raymarine - Moderator - 06-23-16, 04:12 PM
|
User(s) browsing this thread: 1 Guest(s)