Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
cpt 200 be mounted higher than a normal skimming transducer
03-27-17, 01:13 PM (This post was last modified: 03-27-17 02:08 PM by Chuck - Raymarine - Moderator.)
Post: #1
cpt 200 be mounted higher than a normal skimming transducer
I understand that they now recommend that the cpt 200 be mounted higher than a normal skimming transducer. Will it hurt/overheat the transducer if it is totally out of the water at high speed?

See my crude diagram for more info

Thanks, Rich
Find all posts by this user
Quote this message in a reply
03-27-17, 02:14 PM
Post: #2
RE: cpt 200 be mounted higher than a normal skimming transducer
Welcome to the Raymarine Forum Rich,

As you have suggested the CPT-200 can indeed be installed higher on the transom to reduce spray and the dynamic forces that it may be exposed to. I don't suspect that mounting the CPT-200 higher will be an issue for your boat until the speed approaches that which will cause aeration from the step. In short, it is recommended that you proposed location be tested ... I believe that you will find that it works satisfactorily while at trolling speed.
Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)