Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
E120 to ES127 upgrade
04-18-17, 01:38 PM (This post was last modified: 04-18-17 01:46 PM by Chuck - Raymarine - Moderator.)
Post: #2
RE: E120 to ES127 upgrade
Welcome to the Raymarine Forum Rich,

The cable of a transducer which has been designed to be mated to the transducer socket of a CP370/CP300/DSM30/DSM300/DSM250 may be extended up to 5m with an E66010 Transducer Extension Cable. The E66066 Transducer Adapter Cable may then be added to this extension cable to permit the currently installed transducer to be mated to the Transducer socket of the eS127 MFD. The power output of an ax7/cx7/e7D/ex7/eSx7 MFD's transducer socket is limited 600W, whether it is interfaced to a 600W, 1kW, or 2kW transducer. Should the currently installed transducer be a 600W transducer, then performance should be very close to that of the DSM. However, should you be fishing in depths greater than 1000' and a 1kW or 2kW be installed onboard, then depth performance would similar to that of a 600W transducer. Should a 1kW or 2kW transducer be installed onboard, and you fish in depths greater than 1000', and the DSM be unreliable, then it would be recommended that the DSM be replaced with a CP370.
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
E120 to ES127 upgrade - WWMS - 04-16-17, 07:40 AM
RE: E120 to ES127 upgrade - Chuck - Raymarine - Moderator - 04-18-17 01:38 PM
RE: E120 to ES127 upgrade - WWMS - 04-18-17, 05:21 PM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)