Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
ST50+ Wind factory reset
03-07-16, 11:19 AM
Post: #1
ST50+ Wind factory reset
Good morning. Last week I successfully repaired my ST50+ Wind (without schematics!); there was a faulty semiconductor on the anemometer board in the masthead transducer and also a faulty transistor in the control head. I want to perform a factory reset and then linearize and calibrate the transducer again. I found the procedure to do the factory reset for an ST60+ Wind in that manual, but I cannot find the factory-reset procedure for the ST50+. Can you help? Thanks in advance.
Find all posts by this user
Quote this message in a reply
03-09-16, 03:47 PM
Post: #2
RE: ST50+ Wind factory reset
There is no Reset with the ST50+ product line. You can adjust the alignment, but that is it. The ST50+ wind instrument needed a machine in our service department to reset to board. That is no longer available.
Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)