Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
eSeries chart plotter
03-09-16, 11:34 AM
Post: #1
eSeries chart plotter
How is it possible to save measurement choice in customisation of the Navionics chart on the eSeries plotter? I wish to have measurements shown in NM and meters (NM & m) which is possible from - Home Screen- Customise-Units set up-NM & m. However, after power down, the unit always defaults to NM and feet. How can the choice be saved?
Find all posts by this user
Quote this message in a reply
03-09-16, 12:44 PM (This post was last modified: 03-25-16 08:24 AM by Chuck - Raymarine - Moderator.)
Post: #2
RE: eSeries chart plotter
Welcome to the Raymarine Technical Forum Calvin,

Please click here to view a FAQ addressing how to determine the version of software which is installed within your MFD. What version of a/c/e/eS/gS-Series MFD software is installed within your MFD?
Visit this user's website Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)