Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Depth to the iTC5
06-23-17, 09:46 AM
Post: #1
Depth to the iTC5
I wired my DST 800 to the iTC-5 in the following manner: unprotected wire to the shield receptacle, the blue and black wires to their respective colors. Speed and the wind seem to work okay, but the depth still gets a blinking light. I am not in the water so I didn't expect an accurate read, but I am getting no reading at all. Is this common?
Find all posts by this user
Quote this message in a reply
06-23-17, 03:06 PM (This post was last modified: 06-23-17 03:06 PM by Chuck - Raymarine - Moderator.)
Post: #2
RE: Depth to the iTC5
Welcome to the Raymarine Forum Sam.

The system is behaving normally. One would not typically expect that a low power instrument depth transducer would be capable of sensing any depth when the transducer is out of the water or located in water having a depth which is less than 3' beneath the transducer.
Visit this user's website Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)