Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
EV-150 - Voltage - Pump Supply
06-27-17, 02:33 PM (This post was last modified: 06-27-17 02:37 PM by Chuck - Raymarine - Moderator.)
Post: #2
RE: EV-150 - Voltage - Pump Supply
Welcome to the Raymarine Forum Brett,

The ACU-150 is designed for use with the M81120 12VDC Type 1 Hydraulic Pump. Please verify that is hasn't been interfaced to a 24VDC hydraulic pump by examining the pump's label for the pump's part number.

If interfaced to the correct model of hydraulic pump, then it is recommended that the ACU-150 be bypassed to test the autopilot's hydraulic pump. To do so,
1) the rudder should be centered,
2) the pump's power leads should be temporarily disconnected from the ACU-150.
3) the pump's power leads will then be connected momentarily to +12VDC and -12VDC to verify that the pump is able to drive the rudder in one direction.
4) the pump's power leads will be disconnected from +12VDC and -12VDC
5) Steps 1 through 4 will be repeated, this time reversing the connections to +12VDC and -12VDC to verify rudder movement in the opposite direction.

Is your pump operating properly when connected directly to power?
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: EV-150 - Voltage - Pump Supply - Chuck - Raymarine - Moderator - 06-27-17 02:33 PM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)