Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Radar not working - No Data error
08-01-17, 07:28 AM
Post: #1
Radar not working - No Data error
My Digital RD418D 4kw radar is not working this season. I have checked the voltage at the unit and it is 12v or more. It appears to warm up, the motor turns for a second and then is shuts down. I have a C series C90 widescreen plotter which shows the No data error. When I selection "on" on the softkey - nothing happens and the "standby/transmit" key is greyed out. Please help.
Find all posts by this user
Quote this message in a reply
08-01-17, 08:36 AM
Post: #2
RE: Radar not working - No Data error
Welcome to the Raymarine Forum Jazz,

Please click here to view a FAQ addressing this subject.
Find all posts by this user
Quote this message in a reply
08-01-17, 09:58 AM
Post: #3
RE: Radar not working - No Data error
Thanks Chuck,
I did read this thread and others before posting. This is where I got the idea to check the voltage at the source.
Is there anything else I can do/test or do I need to send it for repair?
Find all posts by this user
Quote this message in a reply
08-01-17, 10:06 AM
Post: #4
RE: Radar not working - No Data error
Jazz,

Per the referenced FAQ, it is recommended that power alone be switched ON/OFF to awaken the radome. Should this fail to address the problem while the vessel is connected to shore power, then it would be recommended that the radome be sent to Raymarine’s Product Repair Center to be bench checked / serviced.
Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)