Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
ST4000 Drive Motor
10-26-17, 11:32 AM
Post: #1
ST4000 Drive Motor
Hello

My ST4000 is 2005 vintage and has been working fine until recently. Now the charter plotter turns off sometimes when the autopilot is engaged. Is this possibly due the the drive motor age? If so are replacements available?

Thanks

Peter
Find all posts by this user
Quote this message in a reply
10-26-17, 12:03 PM (This post was last modified: 10-26-17 12:05 PM by Chuck - Raymarine - Moderator.)
Post: #2
RE: ST4000 Drive Motor
Welcome to the Raymarine Forum Peter,

It sounds as though the autopilot is placing power demands on the vessel's electrical system which are in excess of that which can sustain operation of both the autopilot and MFD. While it is possible that the components within the drive unit may have worn sufficiently to cause it to draw more power than a new drive unit, the symptom may also be indicative of depleted or weak batteries. Accordingly, it would be inspected to ensure that they are topped off with fluids (should they not be maintenance free), that the electrical connections are free of corrosion and tight, and that the vessel's batteries be fully charged, and afterwards that the system be tested again. Should the problem persist, then it would be recommended that the vessel's batteries be load tested and replaced, should testing indicate so. If load testing determined that the vessel's batteries were in good shape, then indeed the drive unit may either be sent to Raymarine’s Product Repair Center to be bench checked / serviced or replaced.
Find all posts by this user
Quote this message in a reply
10-26-17, 02:28 PM
Post: #3
RE: ST4000 Drive Motor
Batteries are pretty new, have proper water levels and battery charger is funtioning.

Will check batteries and connections.

Thanks

Peter
Find all posts by this user
Quote this message in a reply
10-26-17, 02:41 PM
Post: #4
RE: ST4000 Drive Motor
You're welcome.
Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)