Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] C80 display
12-02-17, 05:28 PM (This post was last modified: 12-06-17 02:00 PM by Chuck - Raymarine - Moderator.)
Post: #1
[CA] C80 display
Our C80 has developed a black brush stroke mark on the display (see photo). Can this be repaired or is it a permanent degradation of the LED display?


Attached File(s)
.jpg  C80.JPG (Size: 110.81 KB / Downloads: 320)
Find all posts by this user
Quote this message in a reply
12-06-17, 02:00 PM
Post: #2
RE: [CA] C80 display
Welcome to the Raymarine Forum Dan,

Should mark shown within your photo be on the surface of the MFD's screen, then you may want to consider using a plastic polish then please click here to view a FAQ addressing possible cleaning compounds which my remove the mark. However, should the mark actually be indicative of a defect within the MFD's LCD, then the MFD's LCD would need to be replaced. Please note that the complete set of parts are no longer available to render the full range of repairs to the C-Series Classic MFDs. However, at the time of this response, there were still approximately half a dozen or so C80 LCDs within the US Repair Center's inventory. Accordingly, it would be recommended that the MFD be serviced sooner rather than later.
Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)